Peugeot 406

since 1996 release

Repair and operation of the car



Peugeot 406
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engine
+ 4. Cooling systems, heating and ventilation
+ 5. Fuel system
+ 6. System of ignition
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Brake system
- 11. Suspension bracket and steering
   11.1. Technical data
   11.2. Rotary fists
   11.3. Replacement of forward hug bearings
   11.4. The lobby is resistant
   11.5. Repair of a forward rack
   11.6. Lower lever of a forward suspension bracket
   11.7. Lower spherical hinge of a forward suspension bracket
   11.8. Stabilizer of cross stability of a forward suspension bracket
   11.9. Coulisse of the stabilizer of cross stability of a forward suspension bracket
   11:10. Lower frame of a forward suspension bracket
   11:11. Nave of a back wheel
   11:12. Replacement of bearings of a back nave
   11:13. Shock-absorber of a back suspension bracket
   11:14. Cylindrical spring of a back suspension bracket
   11:15. Pin of a nave of a back suspension bracket
   11:16. Lower lever of a back suspension bracket
   11:17. Top lever of a back suspension bracket
   11:18. The directing lever of a back suspension bracket
   11:19. Draft of a back suspension bracket
   11:20. Stabilizer of cross stability of a back suspension bracket
   11:21. Coulisse of the stabilizer of cross stability of a back suspension bracket
   11:22. Steering wheel
   11:23. Steering column
   11:24. Intermediate shaft of a steering column
   11:25. Ignition lock
   11:26. Steering mechanism
   11:27. Replacement of protective covers of the steering mechanism
   11:28. Removal of air from system of steering with the amplifier
   11:29. Pump of the amplifier of steering
   11:30. Spherical hinge of steering draft
   11:31. Steering draft
   11:32. Angles of installation of wheels
+ 12. Body
+ 13. Electric equipment
+ 14. Main malfunctions




2438a55b

11:19. Draft of a back suspension bracket

Removal

PERFORMANCE ORDER
1. Lift a back part of the car and record on supports. Remove the corresponding back wheel.
2. Establish a jack under the external end of the lower lever and lift it so that the spring slightly contracted.
3. Put combination tags between a special washer of an internal hinged bolt and the lower frame. At draft installation these tags will allow to keep the angles of installation of a back wheel.
4. Unscrew a nut of fastening of the spherical hinge of back thirst for a pin and take the spherical hinge from a pin.
5. Unscrew a nut of fastening of an internal hinged bolt and remove a special washer. Take a hinged bolt and remove back draft from the car.
6. Completely clear draft of dirt and an anticorrosive covering. Check its state.

Installation

PERFORMANCE ORDER
1. Clear a carving of a hinged bolt and the spherical hinge and grease the surface of contact of new nuts with Molykote G Rapide Plus lubricant.
2. Establish back draft into place and insert a hinged bolt. Establish on a bolt a special washer so that it correctly was established on a bolt and took place against a ledge on the lower frame. Fix it by a new nut, without tightening finally. Combine the tags made before removal and tighten a fastening bolt the required moment.
3. Install the spherical hinge in a pin and fix by a new nut, tightening it the required moment.
4. If necessary make adjustment of angles of installation of a back wheel.