The device, service, repair of Peugeot 406 (since 1996) - 11.18. The directing lever of a back suspension bracket//Peugeot -

Peugeot 406

since 1996 release

Repair and operation of the car



Peugeot 406
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engine
+ 4. Cooling systems, heating and ventilation
+ 5. Fuel system
+ 6. System of ignition
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Brake system
- 11. Suspension bracket and steering
   11.1. Technical data
   11.2. Rotary fists
   11.3. Replacement of forward hug bearings
   11.4. The lobby is resistant
   11.5. Repair of a forward rack
   11.6. Lower lever of a forward suspension bracket
   11.7. Lower spherical hinge of a forward suspension bracket
   11.8. Stabilizer of cross stability of a forward suspension bracket
   11.9. Coulisse of the stabilizer of cross stability of a forward suspension bracket
   11:10. Lower frame of a forward suspension bracket
   11:11. Nave of a back wheel
   11:12. Replacement of bearings of a back nave
   11:13. Shock-absorber of a back suspension bracket
   11:14. Cylindrical spring of a back suspension bracket
   11:15. Pin of a nave of a back suspension bracket
   11:16. Lower lever of a back suspension bracket
   11:17. Top lever of a back suspension bracket
   11:18. The directing lever of a back suspension bracket
   11:19. Draft of a back suspension bracket
   11:20. Stabilizer of cross stability of a back suspension bracket
   11:21. Coulisse of the stabilizer of cross stability of a back suspension bracket
   11:22. Steering wheel
   11:23. Steering column
   11:24. Intermediate shaft of a steering column
   11:25. Ignition lock
   11:26. Steering mechanism
   11:27. Replacement of protective covers of the steering mechanism
   11:28. Removal of air from system of steering with the amplifier
   11:29. Pump of the amplifier of steering
   11:30. Spherical hinge of steering draft
   11:31. Steering draft
   11:32. Angles of installation of wheels
+ 12. Body
+ 13. Electric equipment
+ 14. Main malfunctions





11:18. The directing lever of a back suspension bracket

Removal

PERFORMANCE ORDER
1. Lift a back part of the car and record on supports. Remove the corresponding back wheel.
2. Establish a jack under the external end of the lower lever and lift it so that the suspension bracket spring slightly contracted.
3. Unscrew a nut and take a hinged bolt of fastening of the directing lever to a pin.
4. Unscrew 3 bolts (are specified by shooters) fastenings of a suspension bracket of the directing lever to a body and remove assembly of the directing lever.

Repair

PERFORMANCE ORDER
1. Unscrew a nut and take the hinged bolt fixing a forward suspension bracket of the directing lever.
2. Clear the directing lever of dirt and an anticorrosive covering and check its state.

Installation

PERFORMANCE ORDER
1. Grease bolts with universal Molykote G Rapide Plus lubricant.
2. If the suspension bracket of the directing lever was removed, establish a hinged bolt of fastening of a suspension bracket and screw a new nut, without tightening it it is final.
3. Install the directing lever into place and fix a lever suspension bracket to a body by bolts.
4. Attach the directing lever to a pin, without tightening a nut finally.
5. Establish a wheel and lower the car. Shake the car that all elements of a suspension bracket fell into place. Tighten all bolts and nuts the required moment.