Peugeot 406

since 1996 release

Repair and operation of the car



Peugeot 406
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engine
+ 4. Cooling systems, heating and ventilation
+ 5. Fuel system
+ 6. System of ignition
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Brake system
- 11. Suspension bracket and steering
   11.1. Technical data
   11.2. Rotary fists
   11.3. Replacement of forward hug bearings
   11.4. The lobby is resistant
   11.5. Repair of a forward rack
   11.6. Lower lever of a forward suspension bracket
   11.7. Lower spherical hinge of a forward suspension bracket
   11.8. Stabilizer of cross stability of a forward suspension bracket
   11.9. Coulisse of the stabilizer of cross stability of a forward suspension bracket
   11:10. Lower frame of a forward suspension bracket
   11:11. Nave of a back wheel
   11:12. Replacement of bearings of a back nave
   11:13. Shock-absorber of a back suspension bracket
   11:14. Cylindrical spring of a back suspension bracket
   11:15. Pin of a nave of a back suspension bracket
   11:16. Lower lever of a back suspension bracket
   11:17. Top lever of a back suspension bracket
   11:18. The directing lever of a back suspension bracket
   11:19. Draft of a back suspension bracket
   11:20. Stabilizer of cross stability of a back suspension bracket
   11:21. Coulisse of the stabilizer of cross stability of a back suspension bracket
   11:22. Steering wheel
   11:23. Steering column
   11:24. Intermediate shaft of a steering column
   11:25. Ignition lock
   11:26. Steering mechanism
   11:27. Replacement of protective covers of the steering mechanism
   11:28. Removal of air from system of steering with the amplifier
   11:29. Pump of the amplifier of steering
   11:30. Spherical hinge of steering draft
   11:31. Steering draft
   11:32. Angles of installation of wheels
+ 12. Body
+ 13. Electric equipment
+ 14. Main malfunctions





11:17. Top lever of a back suspension bracket

GENERAL INFORMATION

Removal of the lower frame

The internal hinged bolt of the top right lever is specified by an arrow.

RIGHT LEVER

Removal

For removal of an internal hinged bolt of the top right lever it is necessary to lower completely a back suspension bracket and the lower frame (see rice. Removal of the lower frame). It needs to be carried out at the station.

LEFT LEVER

Removal

PERFORMANCE ORDER
1. Lift a back part of the car and record on supports. Remove the corresponding back wheel.
2. Establish a jack under the external end of the lower lever and lift a jack so that the spring was slightly compressed.
3. Unscrew nuts, take internal hinged bolts.
4. Unscrew nuts, take external hinged bolts and take the lever from under the car, exempting it at the same time from fastening of a cable of the emergency brake.
5. Clear the lever of dirt and an anticorrosive covering and check its state.

Installation

PERFORMANCE ORDER
1. Grease hinged bolts with Molykote G Rapide Plus lubricant.
2. Install the lever into place, insert hinged bolts and screw on them nuts, without tightening finally.
3. Establish a wheel and lower the car. Shake the car that all elements of a suspension bracket rose on the places. Tighten nuts of fastening of the top hinged bolts the required moment.