Peugeot 406

since 1996 release

Repair and operation of the car

Peugeot 406
- 1. Maintenance instruction
   - 1.1. Introduction
      1.1.1. If the engine is not started and the starter does not work
      1.1.2. Start from an external source (other car)
      1.1.3. If the engine is not started even if the starter works normally
      1.1.4. Check of tightness of connections
      1.1.5. Towage
      1.1.6. Places of weekly check
      1.1.7. General dashboard
      1.1.8. Remote infrared control
      1.1.9. Identification card
      1.1.10. Blocking of back doors from opening by children
      1.1.11. Remote radio control by blocking of doors
      1.1.12. Lever of opening of the hatch of a mouth of the fuel tank
      1.1.13. Electronic anticreeping system
      1.1.14. Fuel supply shutdown valve
      1.1.15. Catalytic converter
      1.1.16. The dashboard (cars with the petrol and diesel engine)
      1.1.17. Dashboards (cars with the petrol engine)
      1.1.18. The dashboard (cars with the automatic transmission)
      1.1.19. Dashboards (cars with the diesel engine)
      1.1.20. Dashboard signaling devices
      1.1.21. Windshield screen wiper
      1.1.22. Electric heater of back glass and external rear-view mirrors
      1.1.23. Adjustment of provision of a steering wheel
      1.1.24. On-board computer
      1.1.25. Heating and ventilation
      1.1.26. Air conditioner
      1.1.27. Automatic conditioner of air
      + 1.1.28. Safety cushions
      1.1.29. Hours, panel illumination
      1.1.30. Transmission
      1.1.31. Speed regulator
      + 1.1.32. Electric equipment
      1.1.33. Wheels and tires
      1.1.34. Towage of the car
      1.1.35. Identification data
      1.1.36. Technical characteristics
      1.1.37. Fuel consumption of cars
      1.1.38. Autoradio tape recorder 4030
      1.1.39. The autoradio tape recorder with the CD player 4050
      1.1.40. Control of devices of external lighting
      1.1.41. Adjustment of seats
      1.1.42. Adjustment of headlights
+ 2. Maintenance
+ 3. Engine
+ 4. Cooling systems, heating and ventilation
+ 5. Fuel system
+ 6. System of ignition
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Brake system
+ 11. Suspension bracket and steering
+ 12. Body
+ 13. Electric equipment
+ 14. Main malfunctions

1.1.39. The autoradio tape recorder with the CD player 4050

GENERAL INFORMATION

Forward panel and governing bodies

1–6. Buttons 1-6. Preliminary control (radio receiver). Choice of a compact disk (CD player). Button 6: inclusion/switching off of system of noise reduction of Dolby BNR (player of cartridges)
7. ON button. Inclusion / switching off of food
8. - Button. Reduction of volume of sound, reduction of low frequencies, reduction of high frequencies, balance of the left / right columns, balance of forward / back columns
9. + button. Increase in volume of sound, strengthening of low frequencies, strengthening of high frequencies, balance of the left / right columns, balance of forward / back columns
10. BAL/FAD button. Single pressing: balance of the left/right columns. Double pressing: balance of forward/back columns
11. BAS/TRE button. Single pressing: choice of adjustment of a timbre of low frequencies. Double pressing: choice of adjustment of a timbre of high frequencies
12. TA/AF button. Short pressing: a priority of information on a road situation (THAT indicator is switched on). Long pressing: inclusion / switching off of the AF function of automatic search of frequency of broadcasting of the chosen RDS station at which the best reception of a signal is provided
13. BND/AST button. Short pressing: Switching of ranges of FM1/FM2/AST/MW/LW. Long pressing: inclusion of function of automatic storing of stations in the range of FM (Autostore)

14. OPEN button. Opening / closing of a forward blind
15. Button. Short pressing: automatic reversion. Long pressing: extraction of the cartridge
16. Forward blind
17. Player of cartridges
18. Button. Manual search of radio stations, search of the beginning of the previous record on the cartridge, search of the beginning of the previous path on the CD player
19. Button. Automatic search of radio stations, bystry rewind of a film of the cartridge back, search of the beginning of the previous path on the CD player
20. Button. Manual search of radio stations, search of the beginning of the following record on the cartridge, search of the beginning of the following path on the CD player
21. Button. Automatic search of radio stations, bystry rewind of a film of the cartridge forward, bystry movement of a head by the beginning of a compact disk
22. SCN/RDM button. Short pressing: scanning of stations of preliminary control (radio receiver), scanning of records on the cartridge, scanning of paths of a compact disk
23. SRC/button. Short pressing: switching of an operating mode of the radio tape recorder (receiver / cartridge / CD player). Long pressing: shutdown of a sound
24. The light indicator of the protection device from theft

Indications of the digital display

1. Frequency of the accepted radio signal and range, the name of the accepted station, other information
2. The AF function is included (search of frequency for improvement of quality of reception of a signal)
3. THAT mode (a priority of information on a road situation) is included
4. The accepted station transfers information on a road situation
5. The accepted station is included into EON network

6. Reception of a stereosignal
7. Figure 1-6 – number of the fixed control on the receiver, the room of a compact disk in shop
8. The Dolby BNR system is included
9. Reproduction of the "metal" cartridge or "is lame"
10. The mode of automatic storing of FM stations of range is included

Remote control of the lever on a steering column

A. Increase in volume of sound
B. Reduction of volume of sound
C. Automatic search of stations, search of the beginning of the following record on the cartridge, search of the beginning of the following path on the CD player
D. Automatic search of stations, search of the beginning of the previous record on the cartridge, search of the beginning of the previous path on the CD player

E. Choice of an operating mode of the radio tape recorder (receiver / player audio cassettes / CD player).
F. The choice of range (one contact), a reverse of the direction of reproduction of record on the cartridge, the choice of the following compact disk (one contact)

Technical characteristics

Protection against theft: the coded device with a 4-unit code.

Remote control: the lever with governing bodies installed on a steering column.

Audio system:

– shutdown of a sound.
– output power: 4х30 W (4х10 W) at coefficient of nonlinear distortions to 1%.

Radio receiver: system of radio data of RDS.

Frequency ranges of the receiver:

– FM: 87,5–108 MHz;
– MW (average waves): 531–1629 kHz;
– LW (long waves): 144–288 kHz.

The number of the fixed settings:

– FM (automatic storing in the AST mode): 6;
– FM (manual storing): 12 (2 subranges of FM1 and FM2 on 6 stations);
– MW (manual storing): 6;
– LW (manual storing): 6.

Player of audio cassettes:

– automatic reversion
– automatic tape detector
– search of record in pauses
– scanning of records
– system of noise reduction Dolby B

CD player:

– shop on 6 compact disks
– bystry movement of the reading-out head
– automatic search of a path
– scanning of paths
– casual order of reproduction of records.

All messages concerning operating modes of the radio tape recorder are output to the central display of the control panel of the car.

The coded device against theft

The device is executed on the basis of the microprocessor. After disconnection of the autoradio tape recorder from the car power supply network (removal of the accumulator, dismantle of the radio tape recorder or its initial installation) it is necessary to enter a safety code. The radio tape recorder will be able to be switched on only after input of the correct code.

Input of a code

PERFORMANCE ORDER

1. Turn on the radio tape recorder the ON button. Press the button of 1 preliminary control. On the display will appear 0---. Press several times the buttons 18 or 20 that on the display the first figure of a code appeared (7---).

2. For confirmation of input of the first figure and transition to input of the second figure of a code press the button 1. On the display will appear 70---. Press several times the buttons 18 or 20 that on the display the second figure of a code appeared (73-).

3. Do these operations for input of the correct code and in conclusion press the button 1 for confirmation of input of the fourth figure of a code. If the entered code true, then is heard a short signal of high-pitch tone. The radio tape recorder is ready to work.

Case of input of an incorrect code

If at input of a code the mistake was made, the short signal of low tone will be distributed. On the display the message "ERR CODE" will appear. Repetition of attempt of input of a code is possible only after a pause 1 minute. Duration of the period of expectation increases twice after one more unsuccessful attempt. This period is limited for about 32 minutes. Switching off of the radio tape recorder does not influence duration of an obligatory pause. Counting of time of a pause will be started over again at turning on of the radio tape recorder. After the termination of a pause on the display the message of "CODE" will appear. Now it is possible to enter a code.

The indicator 24 of red color blinks at the included ignition, indicating turning on of the protection device against theft. The indicator dies away at inclusion of ignition or the radio tape recorder.

After a detachment or repeated connection of the accumulator on the display of the radio tape recorder the message of "CODE" is displayed. Enter a code.

Radio receiver

All main functions which are carried out by the radio receiver are similar to the autoradio tape recorder 4030. Besides, the following functions are added:

Scanning of previously chosen radio stations. The radio tape recorder provides a possibility of scanning of six previously chosen stations in any of ranges. In the course of scanning of radio stations it is possible to stop the choice on one of them.

Scanning of previously chosen radio stations working in one range. Choose the range which you wish to scan. Briefly press the SCN 22 button. When scanning all previously chosen radio stations working in this range serially join. Sequence is defined by order of the cells of memory assigned to buttons 1-6. Scanning begins with radio station which is brought in a cell of memory of the button 1, or from the radio station following for chosen at present. The approximate duration of listening of each station (THAT mode is switched off) makes:

– five seconds at high quality of reception;
– about one second at a weak radio signal.

The approximate duration of listening of each station (THAT mode is included) makes:

– five seconds for the radio stations capable to transfer road messages;
– about one second for the radio stations not capable to transfer road messages.

The choice of radio station during scanning. Briefly press the SCN 22 button during listening of the pleasant radio station to leave the radio receiver adjusted on this station. The order of setup of the radio receiver for previously chosen radio stations does not change.

Scanning interruption. For interruption of scanning of previously chosen radio stations:

– choose any radio station;
– choose any function, except included by the TA/AF 12 button.

Player of audio cassettes

Search of the beginning of record in a pause. This function allows to begin reproduction of the current record with the beginning or the subsequent record on a tape. This function is based on searches of pauses between records. Search of the beginning of record can also be carried out by means of the lever of remote control on a steering column.

Search of the beginning of the previous record. For search of the beginning of the current record press the button 18. In the course of search of the beginning of record the sound is disconnected and on the display the message of "PREV 1" After finding of the beginning of record is displayed reproduction is resumed. This function can be also included by means of the lever of remote control. N-fold pressing of the button 18 leads to transition to the beginning (n-1) - й records, considering from current. At the same time on the display the message of "PREV n" is displayed. During search of the beginning of the necessary record the sound is disconnected, and transitions from the beginning of one record by the beginning another are reflected in the display. After finding of the beginning of the necessary record reproduction is resumed. By each pressing of the button 18 value n on the display increases by unit.

Search of the beginning of the following record. For search of the beginning of the following record press the button 20. In the course of search of the beginning of record the sound is disconnected and on the display the message of "NEXT 1" is displayed. After finding of the beginning of record reproduction is resumed. This function can be also included by means of the lever of remote control on a steering column. N-fold pressing of the button 20 leads to transition to the beginning of n-y of record, considering from current. At the same time on the display the message of "NEXT n" is displayed. During search of the beginning of the necessary record the sound is disconnected, and transitions from the beginning of one record by the beginning another are reflected in the display. After finding of the beginning of the necessary record reproduction is resumed. By each pressing of the button 20 value n on the display increases by unit.

Scanning of records. Function of scanning allows to listen quickly to initial fragments of all records on the audio cassette. Scanning is based on use of pauses between records. Briefly press the SCN/RDM 22 button to start scanning. At the same time on the display the message of "SCAN" will be displayed. The player will reproduce 10 second initial fragments of all records on the audio cassette, since record which follows current. For the scanning termination repeatedly briefly press the SCN/RDM 22 button. Reproduction will begin with record on which scanning was interrupted.

CD player

Scanning of a compact disk. Briefly press the SCN/RDM 22 button. At the same time each path of a compact disk will be lost within ten seconds. On the display the message of "SC [number of a path]" is given. For the scanning termination once again briefly press the button "SCN/RDM" 22. Reproduction of a compact disk will be continued from a path which was lost at the time of scanning cancellation.

Reproduction of records in a casual order. Press the button "SCN/RDM" 22 and hold it not less than two seconds. Inclusion of the mode of reproduction of records in a casual order confirms a short sound signal. Reproduction begins with that disk to which you listened at the time of inclusion of this mode. At first the CD player reproduces all records of the current compact disk in a casual order, then passes to the following compact disks. After exhaustion of all stock of compact disks in disk shop the CD player comes back to the first compact disk. At reproduction of records in a casual order on the display the message of "RD [number of a path] of CD" and number of the lost compact disk is constantly given. [Number of a path] defines the provision of record on a compact disk. For cancellation of the mode of reproduction of records in a casual order repeatedly press the SCN/RDM 22 button and hold it not less than two seconds.