| 1. Remove the accumulator a box for installation of the accumulator. |
| 2. Remove the case of the air filter and system of inlet pipes. |
| 3. Lift a forward part of the car and record on supports. Remove a forward wheel and protection of an arch of a wheel. Remove a mudguard from under the engine. |
| 4. Merge oil from the transmission and establish a drain stopper into place. |
| 5. Take a plait of wires of a control lamp of wear of brake shoes from brackets and move it aside. |
| 6. By means of the lever remove spherical hinged connection of a cable from the selector lever on the multipurpose switch of the transmission. Remove a bracket of fastening of a cable to an installation suspension bracket on the transmission. |
| 7. Track an electrical wiring from the multipurpose switch to the socket back, switch-off the socket and take conducting from a support bracket on the transmission. |
| 8. Switch-off the big socket of a plait of wires near a cooler on the transmission. |
| 9. Using clips, press both hoses of a supply of cooling liquid to a cooler. |
| 10. Remove both hoses of a supply of cooling liquid to a cooler. |
| 11. Disconnect the socket from a suspension bracket of the support located above a cooler and remove a support suspension bracket. |
| 12. Disconnect the grounding tire from the transmission. |
| 13. Remove a suspension bracket of a plait of wires and a suspension bracket of support of hoses from the transmission. |
| 14. Disconnect an electrical wiring from the sensor of the drive of a speedometer and the RPM meter, then remove the RPM meter from the transmission. |
| 15. Unscrew bolts of fastening of a starter and move a starter aside, without disconnecting an electrical wiring. |
| 16. Switch-off any remained electrical wiring sockets. |
| 17. Remove both power shafts. |
|
18. From under the car unscrew bolts of fastening of a support to the case of the intermediate bearing of a power shaft and the lower frame. |
| 19. Unscrew bolts of fastening of a pipe of the steering drive with the amplifier to the transmission. |
| 20. Remove the lower frame of a forward suspension bracket. |
| 21. The winch raise the engine on the left side so that the weight of the engine fell on the winch. |
| 22. The second winch raise the transmission for the ear close to a cooler. The automatic transmission weighs more than 90 kg. |
| 23. Turn the engine crankshaft in such situation until through an opening one of bolts of fastening of the hydrotransformer is visible to installation of a starter. |
| 24. Unscrew an available bolt of the hydrotransformer, turn the crankshaft as required and unscrew the remained two bolts. |
|
25. Unscrew the central nut of the left support of a suspension bracket of the power unit. Unscrew two bolts and remove a rubber pillow from an installation suspension bracket. |
| 26. Unscrew the bolts fixing a transmission case to the engine. |
| 27. Displace the transmission to the left and remove it the directing pins. After formation of a sufficient gap fix the hydrotransformer on the transmission by a bolt through a RPM meter opening. |
| 28. Priopustite the engine and the transmission also take the transmission from under the car. |
