Peugeot 406

since 1996 release

Repair and operation of the car



Peugeot 406
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engine
+ 4. Cooling systems, heating and ventilation
+ 5. Fuel system
+ 6. System of ignition
+ 7. Coupling
- 8. Transmissions
   + 8.1. Mechanical transmission
   - 8.2. Automatic transmission
      8.2.1. Technical data
      8.2.2. Replacement of oil in the transmission
      8.2.3. Removal and installation of a cable of the selector
      8.2.4. Removal and installation of the drive of a speedometer
      8.2.5. Removal and installation of a cooler
      8.2.6. Removal and installation of the multipurpose switch
      8.2.7. Removal and installation of the electronic control device (ECU)
      8.2.8. Removal and installation of the automatic transmission
      8.2.9. Capital repairs of the automatic transmission
+ 9. Power shafts
+ 10. Brake system
+ 11. Suspension bracket and steering
+ 12. Body
+ 13. Electric equipment
+ 14. Main malfunctions




2438a55b

8.2.2. Replacement of oil in the transmission

PERFORMANCE ORDER
1. Make a short trip for bringing the transmission to working temperature.
2. Install the car on the elevator or over a viewing hole.
3. Take the index of level of oil, then install a suitable container under a drain stopper of the transmission. The drain stopper is located in the center of a case of the transmission.
4. Unscrew a drain stopper and merge oil from the transmission. Pay attention that only about 3 liters of oil since it is impossible to merge completely oil from the hydrotransformer merge. Clear a drain stopper and remove a sealing washer from a stopper.
5. Establish a sealing washer on a stopper and screw up a stopper into place.
6. Fill in oil in the transmission through an oil level measuring instrument pipe.
7. In the course of an oil dolivka constantly control oil level. At achievement of level to the mark "MAX" in the measuring instrument of level stop a dolivka. Start the engine in the idling mode for several minutes. Switch off the engine and check oil level, if necessary add oil. Make a control trip and repeatedly check oil level.