Peugeot 406

since 1996 release

Repair and operation of the car



Peugeot 406
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engine
+ 4. Cooling systems, heating and ventilation
- 5. Fuel system
   - 5.1. Power supply system of petrol engines
      5.1.1. Technical data
      5.1.2. Air filter and inlet channels
      5.1.3. Accelerator cable
      5.1.4. Accelerator pedal
      5.1.5. System of injection of fuel
      5.1.6. Removal of pressure in fuel system
      5.1.7. Fuel pump
      5.1.8. Fuel tank
      5.1.9. Check of fuel system
      5.1.10. Case of a butterfly valve
      5.1.11. System of injection Bosch Motronic MP511
      5.1.12. System of injection Magneti Marelli 8P
      5.1.13. Inlet collector
      5.1.14. Final collector
      5.1.15. System of production of exhaust gases
   + 5.2. Fuel system of diesel engines
+ 6. System of ignition
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Brake system
+ 11. Suspension bracket and steering
+ 12. Body
+ 13. Electric equipment
+ 14. Main malfunctions




2438a55b

5.1.13. Inlet collector

Removal

OF THE 1.6 LITRES MODELS

PERFORMANCE ORDER
1. Disconnect the negative plug of the accumulator.
2. Remove the air filter.
3. Remove an accelerator cable from the drive of a butterfly valve and disconnect fastenings of a cover of a cable.
4. Unscrew two bolts of fastening of an arm of an electrical wiring to the top part of a collector and move an arm with wires and hoses aside.
5. Release brackets and remove sockets from four fuel nozzles.
6. Remove the giving and returnable fuel hoses from a collector.
7. Weaken collars and remove a hose of the vacuum amplifier of brakes and a hose of ventilation of a case from the top part of a collector. If necessary mark hoses.
8. Unscrew nuts of fastening of a collector and take a collector from a motor compartment. Remove two laying of a collector.

LITRE ENGINES 1.8 AND 2.0

PERFORMANCE ORDER
1. Disconnect the negative plug of the accumulator.
2. Remove the case of throttles, the fuel highway and nozzles.
3. Weaken collars and remove a hose of the vacuum amplifier of brakes and a hose of ventilation of a case from the top part of a collector. If necessary mark hoses.
4. Where it is used, unscrew a bolt of fastening of a pipe of the measuring instrument of level of oil to a collector.
5. Unscrew the nuts and bolts fixing a collector to a head of the block of cylinders and take a collector from a motor compartment. Remove laying of a collector.

Installation

PERFORMANCE ORDER
1. Installation is made in the sequence, the return to removal.
2. Consider the next moments:
     – clear the interfaced surfaces of a collector and a head of the block of cylinders of traces of old laying. Establish new laying and a collector;
     – check that earlier removed hoses are established on the places;
     – adjust an accelerator cable.