Peugeot 406

since 1996 release

Repair and operation of the car



Peugeot 406
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engine
+ 4. Cooling systems, heating and ventilation
- 5. Fuel system
   - 5.1. Power supply system of petrol engines
      5.1.1. Technical data
      5.1.2. Air filter and inlet channels
      5.1.3. Accelerator cable
      5.1.4. Accelerator pedal
      5.1.5. System of injection of fuel
      5.1.6. Removal of pressure in fuel system
      5.1.7. Fuel pump
      5.1.8. Fuel tank
      5.1.9. Check of fuel system
      5.1.10. Case of a butterfly valve
      5.1.11. System of injection Bosch Motronic MP511
      5.1.12. System of injection Magneti Marelli 8P
      5.1.13. Inlet collector
      5.1.14. Final collector
      5.1.15. System of production of exhaust gases
   + 5.2. Fuel system of diesel engines
+ 6. System of ignition
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Brake system
+ 11. Suspension bracket and steering
+ 12. Body
+ 13. Electric equipment
+ 14. Main malfunctions




2438a55b

5.1.10. Case of a butterfly valve

Removal

PERFORMANCE ORDER
1. Disconnect the negative plug of the accumulator.
2. Remove the air filter.
3. Remove an accelerator cable from the drive of a butterfly valve.
4. Remove electric sockets from the sensor of provision of a butterfly valve, elements of heating, the sensor of temperature of the arriving air and the engine of management of idling.
5. Remove a vacuum hose and a hose of ventilation of a case of the engine.
6. Where it is necessary, unscrew bolts or screws and remove an accelerator cable suspension bracket.
7. Unscrew bolts and remove the case of a butterfly valve from an inlet collector together with laying of round section which needs to be replaced.

Installation

PERFORMANCE ORDER
1. Installation is made in the sequence, the return to removal.
2. Consider the next moments:
     – always use a new sealing ring which are established on the collector then accurately install the case of a butterfly valve;
     – check correctness of installation of earlier removed hoses;
     – check correctness of installation of earlier removed sockets;
     – establish an accelerator cable.