The device, service, repair of Peugeot 406 (since 1996) - 3.1.5. A pulley of a bent shaft//Peugeot -

Peugeot 406

since 1996 release

Repair and operation of the car



Peugeot 406
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engine
   - 3.1. Petrol engines
      3.1.1. Technical data
      3.1.2. Check of pressure of compression
      3.1.3. Installation of the mechanism of gas distribution
      3.1.4. Cover of a head of the block of cylinders
      3.1.5. Pulley of a bent shaft
      3.1.6. Casing of a gear belt
      3.1.7. Gear belt
      3.1.8. Mechanism of a tension of a gear belt and pulleys
      3.1.9. Replacement of a sealing ring of a cam-shaft
      3.1.10. Cam-shaft and pushers
      3.1.11. Check and adjustment of gaps of valves of engines 1.6 liters
      3.1.12. Head of the block of cylinders
      3.1.13. Oil pallet
      3.1.14. Oil pump
      3.1.15. Oil heater
      3.1.16. Replacement of consolidations of a bent shaft
      3.1.17. Flywheel
      3.1.18. Suspension bracket of the power unit
   + 3.2. Diesel engines
   + 3.3. Repair of the engine
+ 4. Cooling systems, heating and ventilation
+ 5. Fuel system
+ 6. System of ignition
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Brake system
+ 11. Suspension bracket and steering
+ 12. Body
+ 13. Electric equipment
+ 14. Main malfunctions





3.1.5. Pulley of a bent shaft

Removal

PERFORMANCE ORDER
1. Take off an auxiliary driving belt.
2. For fixing of the crankshaft of the engine from a provorachivaniye the assistant has to include the fourth transfer and press against the stop a foot brake. At this time weaken a bolt of fastening of a pulley of the crankshaft. If the engine is removed from the car, record a gear wreath of a flywheel a clamp. Do not fix the crankshaft at all, using an opening in a pulley for installation of the mechanism of gas distribution.
3. Unscrew a bolt and remove a pulley from the crankshaft. If the pulley is established on the sliding landing to the crankshaft with application of a spline or pin, remove them. If a pulley напрессован on the crankshaft, remove it by means of a stripper.

Installation

PERFORMANCE ORDER
1. Establish a segment spline in a crankshaft flute. Install a pulley on the crankshaft, combining a groove on a pulley with a segment spline.
2. Clear a carving of a bolt of fastening of a pulley and grease it with means against unscrewing (Peugeot recommends Loctite Frenetanche use).
3. Screw up a bolt with a washer of fastening of a pulley.
4. Establish and adjust a tension of an auxiliary driving belt.