| 1. Install the car on the flat horizontal platform, block back wheels, lift a forward part of the car and record on supports. Remove both forward wheels. |
| 2. Open a cowl and fix it in vertical position. |
| 3. Disconnect the negative plug of the accumulator. |
| 4. Merge cooling liquid from the cooling system. |
| 5. Remove both power shafts. |
| 6. Remove the case of the air filter and system of inlet pipes. Unscrew bolts and remove an arm of support of the air filter. |
| 7. On models with the diesel engine 2.1 liters remove the fuel ECU system and the control unit. |
| 8. Disconnect an accelerator cable from the case of throttles or the fuel pump of high pressure. |
| 9. Remove the case of throttles. |
| 10. Remove wires, sockets and other components from the left forward end of a head of the block of cylinders. |
| 11. Merge engine oil and remove an oil filter. Clear and establish a drain stopper, tightening it the required moment. |
| 12. Merge oil from the transmission, establish drain and jellied traffic jams and tighten them the required moment. |
| 13. Disconnect wires from the transmission. |
| 14. Remove a cable of the drive of a speedometer or an electrical wiring of the converter from the transmission. |
| 15. Using a screw-driver edge as the lever, disconnect the mechanism of the choice of transfers from the corresponding spherical hinged connections on the transmission. |
| 16. Remove the sensor of position of the crankshaft. |
| 17. Remove a coupling cable from the lever of switching off of coupling and disconnect it from a transmission case. On the 2.1 liters diesel engines remove the working cylinder of coupling. |
| 18. Remove the pump of the amplifier of steering, without unscrewing from it hydraulic hoses. Using a soft wire, suspend the pump away from the engine. |
| 19. Remove the generator. |
| 20. On models with the conditioner unscrew a bolt of fastening of the compressor and, using a soft wire, fix it away from the engine. |
| 21. On engines 2.1 liters unscrew a bolt of an additional suspension bracket from a forward part of the block of cylinders. |
| 22. Remove a radiator. |
23. On cars with petrol engines perform the following operations:
– depressurize fuel system and disconnect the giving and returnable fuel hoses;
– switch-off electric sockets of fuel system;
– disconnect the ventilation valve from an inlet collector;
– remove a reception exhaust pipe. |
| 24. On models with diesel engines disconnect hoses of giving and return of fuel. |
| 25. Release collars and remove heater hoses from an adapter on a partition of a motor compartment. |
|
|
| 26. Track a plait of wires from the engine to the socket in a motor compartment. Switch-off sockets, take rings of fastening and remove sockets, previously having noted their arrangement (shooter). Check that all sockets are switched-off and the electrical wiring is taken from brackets and supports and will not prevent removal of the engine. |
| 27. Hook on the load-lifting mechanism for suspension brackets on a head of the block of cylinders and lift until the weight of the engine is not perceived by the load-lifting mechanism. |
| 28. Remove the right and left suspension brackets of the power unit. |
| 29. From below the car unscrew nuts and bolts of fastening of limiters of the course to the lower frame and the engine and remove them. |
| 30. Check that all elements interfering removal of the engine are removed or disconnected. |
|
31. Lift the engine from a motor compartment up. On models with ABS it is necessary to show big care not to damage ABS in the course of removal of the engine. |
| 32. After extraction of the engine from a motor compartment lower it on the earth ahead of the car. |
