Peugeot 406

since 1996 release

Repair and operation of the car



Peugeot 406
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engine
+ 4. Cooling systems, heating and ventilation
+ 5. Fuel system
+ 6. System of ignition
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
- 10. Brake system
   10.1. Technical data
   10.2. Pumping of the hydraulic brake system
   10.3. Brake pipelines and hoses
   10.4. Replacement of front brake shoes
   10.5. Replacement of back brake shoes
   10.6. Replacement of back brake shoes on drum brakes
   10.7. Forward brake disk
   10.8. Back brake disk
   10.9. Back brake drum
   10:10. Support of a forward brake
   10:11. Support of a back wheel
   10:12. Back brake cylinder
   10:13. Main brake cylinder
   10:14. Brake pedal
   10:15. Vacuum amplifier of brakes
   10:16. Unilateral valve of the vacuum amplifier of brakes
   10:17. Adjustment of the emergency brake
   10:18. Lever of the emergency brake
   10:19. Cable of the emergency brake
   10:20. Brake shoes of the emergency brake (model with disk brakes)
   10:21. The valve of adjustment of pressure in the brake system
   10:22. Stoplight switch
   10:23. Anti-blocking system of brakes (ABS)
   10:24. The vacuum pump (cars with the diesel engine)
   10:25. Check of the vacuum pump on cars with diesel engines
+ 11. Suspension bracket and steering
+ 12. Body
+ 13. Electric equipment
+ 14. Main malfunctions




2438a55b

10:20. Brake shoes of the emergency brake (model with disk brakes)

Removal

PERFORMANCE ORDER
1. Remove a brake disk and note an arrangement of all details of the emergency brake.
2. Using a special key, squeeze the top fixing spring of a brake shoe, turn it on 90 ° and remove from a brake board.
3. Disconnect the top returnable spring of brake shoes.
4. Release and remove the regulator.
5. Exempt the top block from the mechanism of a release and remove the lower returnable spring of brake shoes.
6. Remove the lower fixing spring of a brake shoe and remove a block of the emergency brake.
7. Disconnect (shooter) a cable of the emergency brake from the mechanism of a release of brake shoes.
8. Check a state and wear of brake shoes of the emergency brake. The minimum thickness of an overlay of a brake shoe makes 1 mm. At installation of blocks it is necessary to use new returnable springs.

Installation

PERFORMANCE ORDER
1. Clear details of a back brake. Apply lubricant with high temperature of melting on places of contact of blocks with a brake board.
2. Check that the mechanism of a release of brake shoes is correctly assembled, then connect it to the end of a cable of the emergency brake.
3. Establish the lower block of the emergency brake and fix it by the fixing spring.
4. Establish the top block and the lower returnable spring. Check correctness of installation of the top brake shoe and fix it by the fixing spring.
5. Install the regulator between brake shoes. Establish capture of the top returnable spring on the lower block, then on the top block.
6. Center the provision of brake shoes.
7. Establish a brake disk.