Peugeot 406

since 1996 release

Repair and operation of the car



Peugeot 406
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engine
   + 3.1. Petrol engines
   - 3.2. Diesel engines
      3.2.1. Technical data
      3.2.2. Check of pressure of compression
      3.2.3. Installation of the mechanism of gas distribution
      3.2.4. Cover of a head of the block of cylinders
      3.2.5. Pulley of a bent shaft
      3.2.6. Casing of a gear belt
      3.2.7. Gear belt
      - 3.2.8. Pulleys of a gear belt
         3.2.8.1. Camshaft pulley
         3.2.8.2. Crankshaft pulley
         3.2.8.3. Pulley of the fuel pump of high pressure
         3.2.8.4. Cooling system pump pulley
      + 3.2.9. Right engine mount and mechanism of a tension of a gear belt
      3.2.10. The directing roller of a gear belt
      3.2.11. Cam-shaft and pushers
      3.2.12. Check and adjustment of gaps of valves
      + 3.2.13. Removal and installation of a head of the block of cylinders (engines 1.9 liters)
      3.2.14. Removal and installation of the oil pallet
      3.2.15. Removal and installation of the oil pump
      + 3.2.16. Replacement of sealing rings of the crankshaft
   + 3.3. Repair of the engine
+ 4. Cooling systems, heating and ventilation
+ 5. Fuel system
+ 6. System of ignition
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Brake system
+ 11. Suspension bracket and steering
+ 12. Body
+ 13. Electric equipment
+ 14. Main malfunctions




2438a55b

3.2.8.3. Pulley of the fuel pump of high pressure

Removal

PERFORMANCE ORDER
1. Take off a gear belt.
2. Remove 8 mm the adjusting bolts fixing a pulley of the fuel pump from a provorachivaniye.
3. On some models the pulley can be equipped with a stripper which consists of the plate attached by bolts to a pulley. On models without stripper the pulley can be removed from a shaft, using a plate and two bolts which are screwed up in the openings provided in a pulley.
4. Record a shaft of the fuel pump of high pressure from a provorachivaniye, using the special tool.
5. On models with the built-in stripper unscrew a nut of fastening of a pulley and remove a pulley, and also a segment spline from a pump shaft.
6. On models without the built-in stripper partially unscrew a nut of fastening of a pulley, establish the improvised stripper and screw up two bolts until the pulley is not removed from a pump shaft. Remove a pulley and a segment spline.

Installation

PERFORMANCE ORDER
1. Establish a segment spline in a groove on a pump shaft.
2. If the built-in stripper was removed from a pulley, then screw in two bolts of a stripper in a pulley.
3. Establish a pulley and fix it by a nut, having tightened it the required moment. At the same time hold a pulley from a provorachivaniye.
4. Check that adjusting bolts and a core are established in openings of pulleys of a cam-shaft, the fuel pump of high pressure and a flywheel.
5. Establish a gear belt on a pulley of the fuel pump of high pressure so that the tags made on a belt and a pulley before removal were combined.
6. Adjust a tension of a gear belt.
7. Establish casings of a gear belt.