The device, service, repair of Peugeot 406 (since 1996) - 9.4. Replacement of the intermediate bearing of the right power shaft//Peugeot -

Peugeot 406

since 1996 release

Repair and operation of the car



Peugeot 406
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engine
+ 4. Cooling systems, heating and ventilation
+ 5. Fuel system
+ 6. System of ignition
+ 7. Coupling
+ 8. Transmissions
- 9. Power shafts
   9.1. Technical data
   9.2. Removal and installation of power shafts
   9.3. Replacement of covers of hinges of equal angular speeds
   9.4. Replacement of the intermediate bearing of the right power shaft
+ 10. Brake system
+ 11. Suspension bracket and steering
+ 12. Body
+ 13. Electric equipment
+ 14. Main malfunctions





9.4. Replacement of the intermediate bearing of the right power shaft

GENERAL INFORMATION

Prevention

For removal of the bearing it is necessary to use a special stripper.


PERFORMANCE ORDER
1. Remove the right power shaft.
2. Check a condition of the bearing which has to rotate easily and evenly and should not have a side play between an internal and external ring. If necessary replace the bearing.
3. Using a universal stripper with the big course, remove the intermediate bearing from a power shaft. Grease an internal ring of the new bearing, using the hammer and the corresponding tube which rests against an internal ring of the bearing. Install the new bearing on a power shaft.
4. Check that the bearing rotated easily and evenly.