Peugeot 406

since 1996 release

Repair and operation of the car



Peugeot 406
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engine
+ 4. Cooling systems, heating and ventilation
+ 5. Fuel system
+ 6. System of ignition
- 7. Coupling
   7.1. Technical data
   7.2. Coupling cable
   7.3. Coupling pedal
   7.4. Hydraulic control system of coupling
   7.5. Leading knot of coupling
   7.6. Coupling switching off mechanism
+ 8. Transmissions
+ 9. Power shafts
+ 10. Brake system
+ 11. Suspension bracket and steering
+ 12. Body
+ 13. Electric equipment
+ 14. Main malfunctions





7.2. Coupling cable

Removal

PERFORMANCE ORDER
1. Disconnect the negative plug of the accumulator.
2. In interior of the car open a cover of an immobilizer and turn on 90 ° a clamp of a cover of a box with fuses. Disconnect the electric socket from a block, unscrew screws of fastening and remove the lower panel from the driver.
3. Remove the air filter and the inlet air channel.
4. In a motor compartment remove a cable of switching off of coupling from the lever of switching off of coupling and a cable cover from an installation suspension bracket, disconnect a cable from a transmission case.
5. In interior of the car remove a cable from a coupling pedal.
6. In a motor compartment take the plug from a partition of a motor compartment and take a cable, releasing it from brackets of fastening and clips.
7. Check a condition of a cable of coupling for existence of wear or other defects.

Installation

PERFORMANCE ORDER
1. Grease a cable of coupling and carry out it through a partition of a motor compartment.
2. Establish a coupling pedal in the top situation.
3. Fix the end of a cable of coupling for a pedal.
4. In a motor compartment establish a coupling cable on a case of the transmission and the lever of switching off of coupling. Fix in a motor compartment a coupling cable by brackets and clips.
5. Several times press a coupling pedal that the mechanism of automatic control of coupling was installed into position and coupling worked normally.
6. Establish earlier removed elements in the lower part of the panel.
7. Install the air filter and connect the accumulator.